RANGE LAND ROVER ROVER 1999 4DR SUV
Security
Battery BRN/LT GRN + (+) UNDER DR DASH OR GO TO BATTERY
Ignition WHT (-)!!!!!! (-) IGN SW HARNESS"SW HARNESS ARE GROUND NOT
Starter01 WHT/RED (-) (-) IGN SW HARNESS "NEGATIVE"
AllDoorTrigger VIO/RED (-) (-) AT BODY CONTROL MOD "BELOW PASS SEAT"
TrunkTrigger VIO/YEL (-) (-) AT BODY CONTROL MOD "BELOW PASS SEAT"
HoodTrigger VIO/WHT (-) (-) BCM UNDER PASS FRONT SEAT
FactoryAlarmDisarm BLU (-) OR BLU/RED PULSE DURING LOCK
ParkingLights ORG/RED (-) (-) BCM BELOW PASS SEAT FRONT SEAT
Remote Start
Battery BRN/LT GRN + (+) UNDER DR DASH OR GO TO BATTERY
Ignition WHT (-)!!!!!! (-) IGN SW HARNESS"SW HARNESS ARE GROUND NOT
Ignition02 +
Ignition03 +
Accessory01 WHT/PNK (-)!! (-) IGN SW HARNESS"GROUND NOT POSITIVE"
Accessory02 +
Starter01 WHT/RED (-) (-) IGN SW HARNESS "NEGATIVE"
AntiTheftSystem NONE
Tach WHT STRIPE (-) DIS COIL PACK REAR OF ENG 2 CYL(INJ 1 CY
SpeedSense YEL/GRN (AC) PIN 11 AT ECM UNDER PASS SEAT TRIM
ParkingLights ORG/RED (-) (-) BCM BELOW PASS SEAT FRONT SEAT
BrakeLights GRN/BLU (+) (+) BCM UNDER PASS SEAT FRONT
Horn VIO/BRN (-) AT BODY CONTROL MOD "BELOW PASS SEAT"
Doorlocks / Window
PowerUnLock YEL (-) (-) LOCATED IN DRIVERS
PowerLock YEL (-) (-) OR GRN /RED ONE WIRE LOCKS
LeftFrontWindow01 LF: GRY/WHT
RightFrontWindow01 RF:GRY/WHT LR+RR:GRY
(DRIVERS DOOR )
LeftRearWindow01 LF:GRY/GRN
RightRearWindow01 RF:GRY/GRN LR+RR:GRY/ORG ( IN RF DOOR)
Convenience
HeadLights BLU (-) (-) BCM UNDER PASS FRONT SEAT
LowSpeedWipers PNK/LT.GRN (- (-) BCM UNDER FRONT PASS SEAT
TrunkRelease WHT (-) (-) AT SWITCH USE RELAY HIGH CURRENT NEG.
4DR SUV
Mobile Audio / Video
Battery BRN/LT GRN + (+) UNDER DR DASH OR GO TO BATTERY
Accessory01 WHT/PNK (-)!! (-) IGN SW HARNESS"GROUND NOT POSITIVE"
Ground -
Amp UNDER PASSENGER SEAT
Control Modules
ECM UNDER PASSENGER SEAT REMOVE TRIM
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
